[Eng] [] []

HomeAbout DunwellProducts & ServicesNewsroomAwardsLinksContact UsRecruitmentSite Map

Products & Services - Chemical Enhanced Process Treatment

[Introduction] [Treatment Process] [Benefits] [Job Reference]

A PHYSIO-CHEMICAL WASTEWAER TREATMENT SYSTEM
(typical arrangement)

OIL-WATER SEPARATOR
Separates free oil from water by using the patented Coalescing Medium. It removes 99% oil from water or 99%water from oil. It can separate oil and grease down to 10ppm when the oil is in free form. Oil-water separator can be used as individual wastewater treatment equipment or as an integral part of a treatment plant.
Handleing capacity(by flowrate)
5litre/ min. to 38,000litre/min.
 
DUNWELL INDUCED AIR FLOATATION (IAF)
Removes most of the suspended solids, oil and grease; and contributes to the partial removal of BOD and COD. Fine bubbles generated by the aerator lift up large flocs to the wastewater surface. The flocs will then be scrapped away by the scraper and discharged as sludge.
Handleing Capacity (by flowrate)
5 m3/hour to 320 m3/hour
 

FILTER PRESS
Functions to dewater sludge. Wet sludge is forced under pressure into the filter chambers by a fluid process pump. The solids are then retained by the filter cloth and become sludge cakes. Once compacted under maximum pump pressure, the cakes can be discharged.
Handleing Capacity (by volume)
0.4 cu.ft. to 100cu.ft.

 

 
ACTIVATED CARBON COLUMN, MEMBRANE OR BIOLOGICAL TREATMENT SYSTEM
Polishes BOD and COD of treated effluents
 
STRAINER
Separates coarse particles from the wastewater feed stream